IP Gateway

Interface between EIB/KNX Bus and ethernet (REG) KNXnet/IP tunneling

The IP GATE serves as an interface to the KNX/EIB. The device can be used as a programming interface for the ETS3. The KNX/EIB bus can be accessed from each point in the LAN. With the IP GATE, a bus programming is also possible through the internet. The IP address can be assigned through a DHCP server or through manual configuration as an ETS parameter. The power supply occurs externally with 12 V to 24 V or alternatively through power-over-ethernet (IEEE 802.3af). 

Technical data:

Electrical safety:
- Protection type (according to EN 60529): IP 20
- Safety low voltage SELV DC 24 V

EMC requirements:
- Fulfills EN 61000-6-2, EN 61000-6-3 and EN 50090-2-2

Environmental conditions:
- Environment temperature during operation: - 5 ... + 45 °C
- Storage temperature: - 25 ... + 70 °C
- Rel. humidity (not condensation): 5 % … 93 %

Approval: EIB / KNX

Mechanical data:
- Casing: Plastic
- Series installation, installation width 2 TE
- Weight: about 100 g
- Fire load: about 1000 kJ

Ethernet:
- 10BaseT (10Mbit/s)
- Supported internet protocols ARP, ICMP, IGMP, UDP/IP and DHCP

Power supply:
- External supply 12-24V
- Alternative: “Power over Ethernet”
- Power input: < 800 mW

Connections:
- EIB/KNX-connection clamp
- LAN-connecting socket RJ-45
- Screw clamps for supply voltage 

Image

The IP GATE serves as an interface to the KNX/EIB. Instead of a RS232, a USB interface can be used. The KNX/EIB bus can be accessed from each point in the LAN.
The power supply occurs externally with 12 V to 24 V or alternatively through power-over-ethernet (IEEE 802.3af).

Operating elements:
- Learn button for EIB/KNX

Display elements:
Learn-LED (red)
Display-LED (green) for EIB/KNX
Display-LED (green) for LAN